The AMC13 register set (and associated uHAL address table) is complex. This page attempts (will attempt!) to document it. The address table files are used for access...
This page describes the production AMC13 C support software. The software is in git here: Current tags: browse AMC13SoftwareHistory $ git clone ssh://git@gitlab...
These instructions assume you have successfully installed and tested your software. See AMC13CppGettingStarted for instructions if you haven`t Actions...
Installation Guide for CC7 (IPBus and AMC13 Software) These instructions are good even with a `fresh` version of CC7, with no previous IPBus or AMC13 installations...
AMC13 IP and MAC Address Assignment The AMC13 has two PCB Tongues. Tongue 1 (T1) and Tongue 2 (T2) each has their own FPGA (Virtex6/Kintex7 for T1, Spartan6 for T...
Each AMC13 as shipped is a 3 board stack (T1, T2, T3). The serial number is set by soldered jumpers on the T2 board (8 bits). On AMC13XG the serial number is printed...
How to program FPGAs using Vivado NOTE: Intended for production testing. If you are attempting to program over JTAG, but do not need to do a memory test, you must...
This page covers the steps to reprogram the MMC in the AMC13. Software Prerequisites 1 AVR/Atmel Studio (newer versions of MMC may require the use of Atmel Studio...