This page contains a table of method declarations and descriptions for the AMC13AddressCppClass AMC13 address C Class . Constructor Method Description...
This page contains a table of method declarations and descriptions for the AMC13 flash C Class. Constructor Method Description AMC13 flash::AMC13 flash...
This page contains a table of method declarations and descriptions for the AMC13 env C Class. Enumerations Enum Typedef Enum Description IPbusVersion...
Below is the official configuration bytes sent by the MMC to the AMC13 via the SPI interface. For a more detailed look at the MMC FPGA SPI interface, see the of Wisconsin...
How to log on to 904 hcal904daq01 is in a brand new, not yet fully configured private network of B 904. To log in you should first log onto lxplus.cern.ch and then...
2013 05 29 hazen Build MMC v2.1 from tom using default settings in AVR studio 6.1 and flash. Payload power comes on, MMC messages look ok but can`t ping at jumper...
The TTT firmware is developed and maintained by Christopher Woodall (chris.j.woodall #64;gmail.com). The MCS files and source can be found at the following link:...
In order to access your device using a JTAG USB interface, you need to make sure that the cable is correctly connected and that there is a live AMC13 which the iMPACT...
amc13 control.py Documentation Notes The primary purpose of this AMC13 python tool is to talk to the board and carry out simple debugging procedures. However...
The following table contains configurable variables for the inialization and state determination of the AMC13 within the xDAQ environment prior to taking a run. These...
Update Firmware using `p flash.py` First, download and install the latest AMC13Python tarball found here. This latest release will contain the latest firmware...
Below are the releases of the standalone, non xDAQ C software for the AMC13. This software requires a CACTUS installation on the host machine. If you have installed...
Charlie`s Acronym List $ ADC: Analog to Digital Converter $ AMC: Advanced Mezzanine Card. An electronics module which mounts in an ATCA or MicroTCA crate...
The DCC2 is intended to be plug compatible with the DCC1. There are some hardware differences: DCC2 occupies the right slot covered by the front panel, while...
HTR to DCC2 links use National DS90CR285/286 Channel Link technology. These are in principle 28 bit links but we only use 24 of them. The low level link format is...