The DCC2 is intended to be plug-compatible with the DCC1. There are some hardware differences:

  • DCC2 occupies the right slot covered by the front panel, while the DCC1 occupies the left slot.
  • All RJ-45 connectors are rotated 180 degrees. This is an unfortunate side-effect of mounting them on the main PC board.
  • There is a new connector for Ethernet at the top. Do not plug TTS or TTC cables in here!

Specification and User Guide

Serial Numbers

Each DCC has a unique serial number, which is set by cutting a set of traces on the PCB. These are located near the back of the board and marked "SN0" thru "SN7". SN0 is the lsb, and a cut jumper corresponds to a '1'.

To readout the serial number, start DCC2Tool.exe as follows:

  DCC2Tool.exe caen:0 19

...where the bus:crate and VME slot are as needed. Enter the command vme/r 0x10. This will display an 8 digit hex value, where the first 4 digits are the serial number in hex. i.e.:

  > vme/r 0x10
  > Read 0x20050000  from offset 0x000010

This corresponds to S/N 2005. All boards should be marked with their serial numbers. Prototype boards have serial numbers 2001...200a. Note that though the serial number is read in hex, the convention is to write the number as decimal i.e. "2010" instead of "200a".

-- EricHazen - 03 Jan 2010


This topic: BUCMSPublic > WebHome > DCC2Documentation > DCC2UserDocumentation
Topic revision: r10 - 09 Oct 2012 - EricHazen
 
This site is powered by the TWiki collaboration platform Powered by PerlCopyright © 2008-2019 by the contributing authors. All material on this collaboration platform is the property of the contributing authors.
Ideas, requests, problems regarding TWiki? Send feedback