Must edit standalone-daq.xml because of a bug somewhere... in the UHTR { ... } section find the line
"if ( SLOT in..." and change to:
if ( SLOT == 2 ) {
(once only) start control hub:
sudo /etc/init.d/controlhub start
Then: sh run-standaone.sh .
Should see ~30 lines of messages with no errors, ending in "Ready.".
Start web browser on cms1 (e.g. "ssh -X cms1; firefox --no-remote").
Go to "localhost:40010" (xDAQ main page). Navigate to:
* hcalSupervisor
* Control Panel
* Setup (again, ~30 lines of messages ending in "New state is:Ready")
* Start
Go back to "localhost:40010" in another tab, open "hcalDTCmanager".
* Peek into...
* Basic View
|