Difference: UHTRSoftwareProcedures (5 vs. 6)

Revision 625 Apr 2016 - DavidZou

Line: 1 to 1
 
META TOPICPARENT name="HcalDTC"
This page contains some uHTRTool software procedures which are useful to an AMC13 debugger and developer.

Contents
Program uHTR Flash
Enable uHTR DAQ Path
Added:
>
>
Setup Clocks
 
Send Local Trigger

Line: 134 to 135
  New presamples : [0] 4 [...] Selection : [-1] 5
Changed:
<
<
New pipeline length : [0] 50
>
>
New pipeline length : [0] 8
  [...]
Added:
>
>
Selection : [-1] 15 TP presamples : [2] 2 Selection : [-1] 16 TP samples : [2] 2
  Selection : [-1] 7 [...] Selection : [-1] 8
Line: 159 to 164
  Module Id : 0 (0x0) BC Offset : 0
Added:
>
>
Old DAQ enabled menu options:
    Selection :  [-1] 3
    New nsamples :  [0] 10 
   [...]
   Selection :  [-1] 4
     New presamples :  [0] 4
   [...]
   Selection :  [-1] 5
     New pipeline length :  [0] 50
   [...]
   Selection :  [-1] 7
   [...]
   Selection :  [-1] 8
   
  1. Now go back to the DAQ menu, check the status, and you should see that your DAQ path is ready to go!

 

Setup Clock

When checking the status of you uHTR, a list of the clocks are reported (for both front and back). These reported clocks should be consistent with the expected clock (see below). Inconsistencies may indicate that you will need to setup clocks.
 
This site is powered by the TWiki collaboration platform Powered by PerlCopyright © 2008-2019 by the contributing authors. All material on this collaboration platform is the property of the contributing authors.
Ideas, requests, problems regarding TWiki? Send feedback