Difference: UHTRSoftwareProcedures (3 vs. 4)

Revision 412 Oct 2013 - DavidZou

Line: 1 to 1
 
META TOPICPARENT name="HcalDTC"
This page contains some uHTRTool software procedures which are useful to an AMC13 debugger and developer.
Line: 158 to 158
  Module Id : 0 (0x0) BC Offset : 0
Added:
>
>

Setup Clock

When checking the status of you uHTR, a list of the clocks are reported (for both front and back). These reported clocks should be consistent with the expected clock (see below). Inconsistencies may indicate that you will need to setup clocks.
 ID[0] IP[192.168.115.8]  Type: uHTR 
 ID of uHTR (-1 for exiting the tool) ::  [0] 
 Front Firmware revision : (00) 00.09.00 
 Back Firmware revision : (00) 00.0b.00 
  Clock expected at    25.0000 MHz :    25.0000 MHz (front)     25.0000 MHz (back) 
  Clock expected at   100.0000 MHz :   100.0000 MHz (front)    100.0000 MHz (back) 
  Clock expected at    40.0800 MHz :    40.0796 MHz (front)     40.0795 MHz (back) 
  Clock expected at    80.1600 MHz :    80.1591 MHz (front)     80.1591 MHz (back) 
  Clock expected at   120.2400 MHz :   120.2387 MHz (front)    120.2387 MHz (back) 
  Clock expected at   160.3200 MHz :   160.3183 MHz (front)    160.3183 MHz (back) 
  Clock expected at   240.4800 MHz :   240.4774 MHz (front)    240.4775 MHz (back) 
  Clock expected at   320.6400 MHz :   320.6366 MHz (front)    320.6366 MHz (back) 
  Clock expected at    11.0000 kHz :    11.2450 kHz (front)     11.2460 kHz (back) 
  Clock expected at     0.1100 kHz :     0.0000 kHz (front)      0.0000 kHz (back) 
  Clock expected at    40.0800 MHz :    40.0796 MHz (front)     40.0795 MHz (back) 
  Clock expected at    40.0800 MHz :    40.0796 MHz (front)     40.0795 MHz (back) 
  Clock expected at   240.4800 MHz :   240.4775 MHz (front)    320.6366 MHz (back) 
The following is the procedure to setup clocks
   CLOCK
      SETUP
         Standard 1.6 Gbps setup (1), Standard 4.8 Gbps setup (2) or custom (3)?  [1] 1
   LUMI
      RESET
   
 

Send uHTR Local Triggers

The following procedure assumes that the backplane link sees Bc0s running both ways between the uHTR and the AMC13. It's also worth saying that the following procedure is from Jeremy, and that upon it's initial test, it did not work. We are not sure what the problem is yet, but this list of command may need to be modified.
 
This site is powered by the TWiki collaboration platform Powered by PerlCopyright © 2008-2019 by the contributing authors. All material on this collaboration platform is the property of the contributing authors.
Ideas, requests, problems regarding TWiki? Send feedback