Difference: FlashMemory (2 vs. 3)

Revision 318 Jun 2012 - EricHazen

Line: 1 to 1
All Flash memory programming is done with the Spartan (T2). From T2 firmware v6 onward, the flash memory is organized as follows:
Line: 8 to 8
0x200000 Spartan
0x400000 Virtex
See AMC13Firmware page for current firmware releases.
 NOTE; earlier versions of the spartan firmware (pre v6) use addres 0x0 for the Spartan. These modules can be reloaded without a cable by writing v6 to 0x0, powercycling to configure from flash, loading the flash according to the table above, and finally powercycling to get the current configuration.

The flash programming may be verified against the mcs files (which must be locally available) with AMC13Tool with the following commands:

This site is powered by the TWiki collaboration platform Powered by PerlCopyright © 2008-2020 by the contributing authors. All material on this collaboration platform is the property of the contributing authors.
Ideas, requests, problems regarding TWiki? Send feedback