| |
|
| |
- Configure FPGA using iMPACT
- Download the following bit file to your computer (in a known, accessible location):
|
|
<
< | |
>
> | |
| | |
|
<
< |
-
- Connect your JTAG cable to the bottom-most of the two 10-pin, rectangular, male sockets on the front panel of your AMC13. Note that "pin 1" is in the upper left-hand corner of the connector
|
>
> |
-
- Connect your JTAG cable to the bottom-most of the two 10-pin, rectangular, male sockets on the front panel of your AMC13 as show here
 . Note that "pin 1" is in the upper left-hand corner of the connector
|
| |
-
- Once your JTAG cable is connected, open the IMPACT software (see iMPACT Installation for installation instructions and Running iMPACT for startup instructions) on the computer which is connected to your JTAG cable
- The software will prompt you about loading past projects and creating new ones. Just say no/cancel to all of these opions.
- Once the main window for IMPACT is up, click on the Boundary Scan icon in the "iMPACT Flows" sub-window.
|
Copyright © 2008-2023 by the contributing authors. All material on this collaboration platform is the property of the contributing authors.