Difference: FlashMemory (16 vs. 17)

Revision 1724 Jul 2014 - DavidZou

Line: 1 to 1
 
META TOPICPARENT name="HcalDTC"
Useful Links
Firmware Files
Line: 57 to 57
 

  • Configure FPGA using iMPACT
Changed:
<
<
    1. Download the following bit file to your computer (in a known, accessible location): amc13T2v0x17.bit.
>
>
    1. Download the following bit file to your computer (in a known, accessible location):
 
    1. Connect your JTAG cable to the bottom-most of the two 10-pin, rectangular, male sockets on the front panel of your AMC13. Note that "pin 1" is in the upper left-hand corner of the connector
    2. Once your JTAG cable is connected, open the IMPACT software (see iMPACT Installation for installation instructions and Running iMPACT for startup instructions) on the computer which is connected to your JTAG cable
    3. The software will prompt you about loading past projects and creating new ones. Just say no/cancel to all of these opions.
Line: 74 to 76
 
  • Program FLASH using iMPACT
Changed:
<
<
    1. Download the desired MCS file to your computer (in a known, accessible location)
>
>
    1. Download the desired MCS file to your computer (in a known, accessible location)
 
    1. Connect your JTAG cable to the bottom-most of the two 10-pin, rectangular, male sockets on the front panel of your AMC13. Note that "pin 1" is in the upper left-hand corner of the connector
    2. Once your JTAG cable is connected, open the IMPACT software (see iMPACT Installation for installation instructions and Running iMPACT for startup instructions) on the computer which is connected to your JTAG cable
    3. The software will prompt you about loading past projects and creating new ones. Just say no/cancel to all of these opions.
 
This site is powered by the TWiki collaboration platform Powered by PerlCopyright © 2008-2019 by the contributing authors. All material on this collaboration platform is the property of the contributing authors.
Ideas, requests, problems regarding TWiki? Send feedback