Difference: FlashMemory (10 vs. 11)

Revision 1126 Mar 2013 - CharlieHill

Line: 1 to 1
 
META TOPICPARENT name="HcalDTC"
Contents
Flash Layout
Line: 10 to 10
 
iMPACT Installation
Running iMPACT
iMPACT Troubleshooting
Changed:
<
<
Spartan Bit File
>
>
Spartan Bit File
 

Flash Layout

Line: 63 to 63
 

  • Configure FPGA using iMPACT
Changed:
<
<
    1. Download the following bit file to your computer (in a known, accessible location): http://ohm.bu.edu/~hazen/test/firmware.cgi
>
>
    1. Download the following bit file to your computer (in a known, accessible location): http://physics.bu.edu/~wusx/download/AMC13/amc13T2v6.bit
 
    1. Connect your JTAG cable to the bottom-most of the two 10-pin, rectangular, male sockets on the front panel of your AMC13. Note that "pin 1" is in the upper left-hand corner of the connector
    2. Once your JTAG cable is connected, open the IMPACT software (see iMPACT Installation for installation instructions and Running iMPACT for startup instructions) on the computer which is connected to your JTAG cable
    3. The software will prompt you about loading past projects and creating new ones. Just say no/cancel to all of these opions.
 
This site is powered by the TWiki collaboration platform Powered by PerlCopyright © 2008-2022 by the contributing authors. All material on this collaboration platform is the property of the contributing authors.
Ideas, requests, problems regarding TWiki? Send feedback