Line: 1 to 1 | ||||||||
---|---|---|---|---|---|---|---|---|
| ||||||||
Line: 126 to 126 | ||||||||
SN 2150 fails memory test on LRB2. This matches the symptoms of the spigots that were not working at P5. | ||||||||
Changed: | ||||||||
< < | SN 2160 Tests fine on lxcmdtest3 @ 43 kHz. Then we run again at 83 kHz (no TTS), HTRs are giving single bit errors which are corrected by DCC, but no UErrs show up on spigot 13 (this was the failure mode at P5). Returning to pile of good spares | |||||||
> > | SN 2160 Tests fine on lxcmdtest3 @ 43 kHz. Then we run again at 83 kHz (no TTS), HTRs are giving single bit errors which are corrected by DCC, but no UErrs show up on spigot 13 (this was the failure mode at P5). Returning to pile of good spares. Instrumented with cables to connect scope probes to monitor 3.3V and 2.5V supplies. Need to test at P5 in fully occupied crate to look for transient spikes. SN 2132 retest VME readout. Still does not work. | |||||||
-- PhilLawson - 27 Jan 2012 | ||||||||
Changed: | ||||||||
< < | SN 2162 Tested on cmsmoe4 in 904. VME readout works just fine. Returning to pile of good spares | |||||||
> > | SN 2132 Tested on cmsmoe4 in 904. VME readout does not appear to work. xDAQ stops after 100 events (this is how many trigger credits are issued). Event Builder hyperdaq does not show any events coming in from the DCC's FED. Wu looks at register dump and states that it appears as if the VME spy buffer was already read out. Did the events get "dropped" in software? Why only for this board? Unclear. Needs further investigation. | |||||||
Changed: | ||||||||
< < | -- PhilLawson - 26 Jan 2012 | |||||||
> > | SN 2162 Tested on cmsmoe4 in 904. VME readout works just fine. Returning to pile of good spares | |||||||
SN 2181 checks out AOK with xDAQ run on lxcmdtest3 post replacement of LRB1 (U11) | ||||||||
Deleted: | ||||||||
< < | -- PhilLawson - 26 Jan 2012 | |||||||
Confirmed that 2153 has bad LRB3 memory -- PhilLawson - 26 Jan 2012 |