|
META TOPICPARENT |
name="HcalDTC" |
|
|
-
- (various firmware include these special firmware located in Wu's Directory
) (as of July 10,2014 the latest DAQLDC firmware: AMC13T1v0x00fb_7k325t.mcs )
- Sending board should have latest "normal" firmware
- Connect hardware correctly
|
|
< < |
-
- The DAQ Link optical fiber cable should be connected to the SFP2 slot (3rd from top, may be labelled DAQ2 or Spare) on the sending AMC13 module
|
> > |
-
- The DAQ Link optical fiber cable should be connected to the SFP slot on the sending AMC13 module (in this example SFP2 slot, 3rd from top, may be labelled DAQ2 or Spare) (NOTE: in xdaq software 12.0.1 or newer SFP0 (top) will be automatically enable, so please us that)
|
|
-
- If an AMC13 is also being used as the receiving module, the other end of the DAQ Link optical fiber cable should be connected to the SFP0 (top slot, may be labelled DAQ0 or DAQ1) on that receiving AMC13 module
- The sender module should also be setup to receive triggers and build events. The below example will use internal L1As and fake events, so you will only need to have a loopback in the TTC SFP (in order to send L1As to itself).
- Initialize your sender AMC13 (detailed information found here) with the
'd' flag (in addition to other desired init flags) to enable the DAQ link. For example:
|