| |
| META TOPICPARENT |
name="AMC13ProductionTesting" |
Programming AMC13 Flash with AMC13ToolFlash |
| |
Input the number corresponding to the mcs file you want to use from the prompt. Here the command is Verify Flash Header (-f vfh) so there is only one file, but multiple files will show up if more than one version is in the current directory. |
|
<
< | Once you have all sectors programmed, run the flash tool again with the -r option to reload the flash memory (or power cycle the board)(NOTE: Do NOT power cycle board until all sectors are programmed successfully, do so will erase the any bit files programmed to T2 and will attempt to apply the firmware currently in flash, which can cause errors if there is nothing available from a given flash sector). |
>
> | Once you have all sectors programmed, run the flash tool again with the -r option to reload the flash memory (or power cycle the board):
AMC13ToolFlash.exe -c SN/c -r
(NOTE: Do NOT power cycle board until all sectors are programmed successfully, do so will erase the any bit files programmed to T2 and will attempt to apply the firmware currently in flash, which can cause errors if there is nothing available from a given flash sector). |
| |
The flash sectors should be programmed in the following order if not using the pa option: |
Copyright © 2008-2023 by the contributing authors. All material on this collaboration platform is the property of the contributing authors.