Difference: AMC13Tool2Recipes (4 vs. 5)

Revision 501 Jun 2015 - DavidZou

Line: 1 to 1
 
META TOPICPARENT name="HcalDTC"
These instructions assume you have successfully installed and tested your software. See AMC13CppGettingStarted for instructions if you haven't
Line: 57 to 57
 programming flash at address 0x2c3b00 programming flash at address 0x208400 % done = 97
Added:
>
>

NOTE: The most recent versions of these program commands should automatically verify the relevant flash sector against the chosen firmware file, but if it does not, use 'vk' and 'vs' respectively for verifying the T1 and T2 (upon using the command select the new firmware file to check against what is programmed in flash). Be sure to verify flash sector prior to reconfiguring or power cycling.


 >reconfigureFPGAs # force reload from flash
Best exit/restart tool after 10s or so
 
This site is powered by the TWiki collaboration platform Powered by PerlCopyright © 2008-2022 by the contributing authors. All material on this collaboration platform is the property of the contributing authors.
Ideas, requests, problems regarding TWiki? Send feedback