Difference: AMC13Tool2 (23 vs. 24)

Revision 2405 Oct 2021 - EricHazen

Line: 1 to 1
 
META TOPICPARENT name="AMC13CppProductionSoftware"
AMC13Tool2 is a command-line utility designed to exercise all functions of the AMC13. The tool can be run in either interactive or scripted mode.
Line: 205 to 205
  The maximum rate which can be specified is about 1MHz but the trigger rules limit it to less than that unless they are disabled (see below). The low 4 bits of the specified rate are ignored (use value is divided by 16, written to a register, and then multiplied by 16 in the firmware).
Changed:
<
<
Note that CMS "standard" trigger rules are applied. Individual rules may be disabled, see Local_L1A_Generator.
>
>
Note that CMS "standard" trigger rules are applied. Individual rules may be disabled, see Local_L1A_Generator.
 
CMS Standard Trigger Rule Number Description
1 No more than 1 trigger per every 2 bunch crossings (50ns)
Line: 503 to 508
 
dump (wu): dump registers in Mr. Wu's format to .txt file with a status (st) command at the end
             Usage:
Changed:
<
<
wu OR wu OR wu OR wu
>
>
wu OR wu OR wu OR wu

NOTE: as of this writing (2021-10-05) the command silently fails if the current directory is not writeable.

  -- EricHazen - 18 Oct 2014 \ No newline at end of file
 
This site is powered by the TWiki collaboration platform Powered by PerlCopyright © 2008-2021 by the contributing authors. All material on this collaboration platform is the property of the contributing authors.
Ideas, requests, problems regarding TWiki? Send feedback