Line: 1 to 1 | ||||||||||
---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||
Line: 12 to 12 | ||||||||||
| ||||||||||
Changed: | ||||||||||
< < |
| |||||||||
> > |
| |||||||||
Startup | ||||||||||
Line: 26 to 26 | ||||||||||
Use the -c argument to specify AMC13 modules to communicate with. | ||||||||||
Changed: | ||||||||||
< < | IP Address | |||||||||
> > | IP Address or Serial Number | |||||||||
The argument after -c may be a numeric I/P address, in the standard form e.g. 192.168.1.120 , or simply the serial number e.g. 67 . | ||||||||||
Changed: | ||||||||||
< < | To specify the control hub protocol, append /c e.g. 192.168.1.120/c (67/c ). Always specify the T2 board (lower) IP address or serial number. The tool will automatically connect to the address specified + 1 for T1. | |||||||||
> > | To specify the control hub protocol, append /c e.g. AMC13Tool2.exe -c 192.168.1.120/c (AMC13Tool2.exe -c 67/c ). Always specify the T2 board (lower) IP address or serial number. The tool will automatically connect to the address specified + 1 for T1. | |||||||||
If you specify an IP address, you must also tell the tool where to find the IPBus address tables.
You can either set the environment variable AMC13_ADDRESS_TABLE_PATH or use | ||||||||||
Line: 179 to 179 | ||||||||||
| ||||||||||
Added: | ||||||||||
> > |
>daq 2 L . | |||||||||
Note: recommend doing 'rd' (daq reset) after changing configuration |