|
META TOPICPARENT |
name="HcalDTC" |
Each AMC13 as shipped is a 3-board stack (T1, T2, T3). The serial number is set by soldered jumpers on the T2 board (8 bits). On AMC13XG the serial number is printed on the front panel label in decimal. |
|
< < |
Serial Number Range |
Board Type/Rev |
Notes |
1-12 |
V1 with Virtex-6 LX 130T and Spartan-6 |
|
16-20 |
V1 with Virtex-6 LX 240T |
|
32-46 |
V2 with Kintex-7, LX 150T Spartan 6 (lx25t) |
|
48-112 |
V2 with Kintex-7, LX 240T Spartan 6 (lx45t) |
2014 Production of 65 |
113-127 and 129-159 |
|
Reserved for future BU production |
160-223 |
V2 with Kintex-7, LX240T Spartan 6 |
CERN Production of up to 64 |
224-255 |
|
Reserved S/N |
|
> > |
Serial Number Range |
Used |
Count |
Board Type/Rev |
Notes |
1-12 |
12 |
12 |
V1 with Virtex-6 LX 130T and Spartan-6 |
|
16-20 |
5 |
5 |
V1 with Virtex-6 LX 240T |
|
21-31 |
0 |
11 |
|
Could be used but see note [1] |
32-46 |
15 |
15 |
V2 with Kintex-7, LX 150T Spartan 6 (lx25t) |
|
47 |
0 |
1 |
|
Unused but see note [1] |
48-112 |
65 |
65 |
V2 with Kintex-7, LX 240T Spartan 6 (lx45t) |
2014 Production of 65 |
113-127 and 129-159 |
0 |
46 |
|
Reserved for future BU production |
160-223 |
? |
64 |
V2 with Kintex-7, LX240T Spartan 6 |
CERN Production of up to 64 |
224-254 |
0 |
31 |
|
Reserved S/N |
255 |
|
|
|
Don't use |
|
| |
|
< < | AMC13PartNumbers and barcode labels |
> > | Notes:
[1] Software expects serial numbers below 48 to use LX150T Spartan chip; to support
newer modules in these serial numbers would require updated software.
See AMC13PartNumbers and barcode labels for details on part numbers and barcode labels. |
|
Information on newest boards (SN48 and larger) are now located in a new board database: VIEW link EDIT link |
| Modules with a T2 version earlier than S6 can be updated first by programming S6 to flash address 0x0 (may require older software) and then using the current software to program the Header (0x0), Golden (0x100000), Spartan (0x200000), and Virtex (0x400000). One this is done, new firmware may be loaded from the flash by software command without power cycle.
|
|
< < | -- EricHazen - 24 Jan 2012, appended J. Rohlf 26 May 2012 |
| \ No newline at end of file |
|
> > |
-- EricHazen - 19 Jun 2015 |